Much attention has gone into the power supply design which is critical to faithfully amplify ultra low level signals. It features several layers of filtration and regulation designed to isolate and create a pure electrical source for signal amplification.
The AC mains is first EMC filtered to remove up to 70dB of unwanted electromagnetic and high frequency interference from being passed through to the power supply.
Spike and transient suppression techniques are also used to minimise unwanted noise appearing in the audible frequency spectrum.
The DC supply fed between the PSU module and the phono stage is balanced and therefore exhibits excellent common mode noise rejection.
The filtered DC is then regulated to ensure that regardless of voltage changes to the AC mains supply the amplifier circuitry is run at a completely steady DC voltage.
The result of this attention to detail is a phono stage which massively improves the quality of vinyl replay and is far in advance of many more costly rivals.
The true test of any product is a personal audition and we invite you to contact us directly or arrange an appointment with one of our dealers.
Gain Settings in dB: 43, 46, 49, 52, 55, 58, 64, 70
Input Impedance Settings in ohms: 20, 22, 30, 68, 82, 91, 100, 150, 180, 200, 240, 360, 390, 470, 650, 750, 820, 1K, 1K2, 1K5, 1K8, 2K2, 3K3, 4K7, 10K, 47K
Capacitance Settings in pF: 0, 25, 50, 75, 100, 125, 150, 175, 200, 225, 250, 275, 300, 325, 350, 375
RIAA deviation – 20Hz – 20kHz +/- 0.5dB
Noise – 1nV per Hz squared
Moving Magnet output range: 1 – 7mV
Moving Coil output Range – 0.05 to 1mV
Power consumption – 2W
Dimensions in mm – 109 x 59 x 190 (W x H x D)
Mains supply – 230V or 110V (factory set)
Inputs: RCA phono sockets
Outputs: RCA phono sockets & 3 Pin XLRs
3 Ground terminals